3d_printing
This is an old revision of the document!
Table of Contents
3D Printing
02/03/2026
White PLA Filament:
I have always wondered why when I print in White, there are always little gaps near edges. At first I just thought that it happens with Black Filament too. I tested it and no it does not print exactly the same. I run Overture Filament only. Years ago I decided to stick with one type of Filament for PLA, PETG, a TPU. I run Calibration for each type material. From what I understand the additives in White that contains Titanium Dioxide. This makes if flow differently and may need to run a slightly higher Temperture.
More to follow later.
BambuLab A1
Ender 5 Plus
Ender 3v2
3d_printing.1770227579.txt.gz · Last modified: by Jon