Differences

This shows you the differences between two versions of the page.

--- 3d_printing [04/16/2026 13:13] – [BambuLab A1] N5JLD
+++ 3d_printing [04/22/2026 10:22] (current) – [3D Printing] added video N5JLD
@@ Line 4: / Line 4: @@
 **White PLA Filament:**
-I have always wondered why when I print in White, there are always little gaps near edges. At first I just thought that it happens with Black Filament too. I tested it and no it does not print exactly the same. I run Overture Filament only. Years ago I decided to stick with one type of Filament for PLA, PETG, a TPU. I run Calibration for each type material. From what I understand the additives in White that contains Titanium Dioxide. This makes if flow differently and may need to run a slightly higher Temperture.
+I have always wondered why when I print in White, there are always little gaps near edges. At first I just thought that it happens with Black Filament too. I tested it and no it does not print exactly the same. I run Overture Filament only. Years ago I decided to stick with one type of Filament for PLA, PETG, a TPU. I run Calibration for each type material. From what I understand the additives in White that contains Titanium Dioxide. This makes if flow differently and may need to run a slightly higher Temperature.
 More to follow later.
+----
+/22/2026
+Watch this video for what to make with the last 10-20 Grams of Material left on the Spool
+<WRAP center round box 60%>
+{{youtube>dxU14l7qXNU?}}
+</WRAP>
 ----
@@ Line 27: / Line 39: @@
 <WRAP center round box 60%>
-{{youtube>J846AzEy6WU-k?}}
+https://www.youtube.com/watch?v=J846AzEy6WU
 </WRAP>