Differences

This shows you the differences between two versions of the page.

--- 3d_printing [02/03/2026 21:31] – [3D Printing] Jon
+++ 3d_printing [04/22/2026 10:22] (current) – [3D Printing] added video N5JLD
@@ Line 4: / Line 4: @@
 **White PLA Filament:**
-I have always wondered why when I print in White, there are always little gaps near edges. At first I just thought that it happens with Black Filament too. I tested it and no it does not print exactly the same. I run Overture Filament only. Years ago I decided to stick with one type of Filament for PLA, PETG, a TPU. I run Calibration for each type material........
+I have always wondered why when I print in White, there are always little gaps near edges. At first I just thought that it happens with Black Filament too. I tested it and no it does not print exactly the same. I run Overture Filament only. Years ago I decided to stick with one type of Filament for PLA, PETG, a TPU. I run Calibration for each type material. From what I understand the additives in White that contains Titanium Dioxide. This makes if flow differently and may need to run a slightly higher Temperature.
 More to follow later.
+----
+/22/2026
+Watch this video for what to make with the last 10-20 Grams of Material left on the Spool
+<WRAP center round box 60%>
+{{youtube>dxU14l7qXNU?}}
+</WRAP>
 ----
 ==== BambuLab A1 ====
+/04/2026
+**Calibrating Filament for the A1**
 ----
+/15/2026
+Inserting a "Pause" into your print, Bambu Lab Studio. Short Video
+[[https://youtube.com/shorts/5FrxuahToEs?si=8hp5xoGGGkmUlUwM|https://youtube.com/shorts/5FrxuahToEs?si=8hp5xoGGGkmUlUwM]] (([[https://www.youtube.com/@makeinspires/shorts|https://www.youtube.com/@makeinspires/shorts]]))
+Loctite Fix for the A1
+<WRAP center round box 60%>
+https://www.youtube.com/watch?v=J846AzEy6WU
+</WRAP>
+<WRAP center round box 60%>
+{{youtube>oyqdWSyvE-k?}}
+</WRAP>
+----
+/16/2026
+Hide your seam in BambuLab Studion
+[[https://youtube.com/shorts/9_Bekyryqus?si=FldIKtFqO8AxsbEd|https://youtube.com/shorts/9_Bekyryqus?si=FldIKtFqO8AxsbEd]]
+----
 ==== Ender 5 Plus ====