Differences

This shows you the differences between two versions of the page.

--- 3d_printing [12/04/2025 18:23] – created Jon
+++ 3d_printing [02/04/2026 18:30] (current) – [BambuLab A1] Jon
@@ Line 1: / Line 1: @@
-=====   3D Printing   =====
+===== 3D Printing =====
+/03/2026
-BambuLab A1
+**White PLA Filament:**
-Ender 5 Plus
+I have always wondered why when I print in White, there are always little gaps near edges. At first I just thought that it happens with Black Filament too. I tested it and no it does not print exactly the same. I run Overture Filament only. Years ago I decided to stick with one type of Filament for PLA, PETG, a TPU. I run Calibration for each type material. From what I understand the additives in White that contains Titanium Dioxide. This makes if flow differently and may need to run a slightly higher Temperture.
-Ender 3v2
+More to follow later.
+----
+==== BambuLab A1 ====
+/04/2026
+**Calibrating Filament for the A1**
+----
+==== Ender 5 Plus ====
+----
+{{ :645749_363515_01_front_zoom.jpg?400 |}}
+==== Ender 3v2 ====
+----